Victron Energy Quattro 48V 8000VA 110A-100A/100A
 - 8kW all-in-one hybrid solar unit

 Quattro-II inverter/charger

 Quattro function plus ESS (Energy Storage System).
 The Quattro-II can be connected to two independent AC sources, such as a utility grid and a generator, or two generators. The Quattro-II will automatically connect to the active source.
 PowerControl and PowerAssist - Increasing grid or generator capacity
 The maximum grid or generator current can be set. The Quattro-II will then take into account the additional AC load and use whatever is extra to charge the battery, preventing the generator or grid from being overloaded (PowerControl function).
 PowerAssist takes the PowerControl principle to the next level. Where peak power is so often only needed for a limited time, the Quattro-II compensates for insufficient generator, shore or grid power by drawing on battery power. When the load decreases, the spare energy is used to recharge the battery.
 Solar power: AC power available even during a power outage
 The Quattro-II can be used in off-grid photovoltaic systems as well as grid-connected photovoltaic systems and other alternative energy systems. It is compatible with both solar charge controllers and grid-connected inverters.
 Two AC outputs
 The main output does not have an interrupt function. The Quattro-II takes over power to the connected appliances in the event of a mains failure or when the shore/generator is disconnected. This happens so quickly (less than 20 milliseconds) that computers and other electronic devices will continue to operate without interruption.
 The second output is only energized when AC power is available at the input. Loads that should not drain the battery, such as a water heater, can be connected to this output.
 Parallel and three-phase operation
 Up to 6 Quatro units can operate in parallel to achieve higher power. For example, six 48/5000/70 units will provide an output power of 25 kW / 30 kVA with a charging capacity of 420 A.
 In addition to parallel connection, three units of the same model can be configured for three-phase output, and up to 6 sets of three units can be connected in parallel per phase for an inverter with a power of 75 kW / 90 kVA and a charging capacity of more than 1200 A.
 On-site system configuration, monitoring and management
 Settings can be changed in a matter of minutes using the VEConfigure software (PC or laptop and MK3-USB interface required).
 Several monitoring and control options are available: Cerbo GX, Color Control GX, Venus GX, Octo GX, CANvu GX, laptop, computer, Bluetooth (with optional VE.Bus Smart dongle), Battery Monitor, Digital Multi Control Panel.
 Remote configuration and monitoring
 Install Cerbo GX or another GX product to connect to the Internet.
 Operating data can be stored and viewed free of charge on our VRM (Victron Remote Management) website. Once connected to the internet, systems can be accessed remotely and settings can be changed.

 More information can be found in the data sheet.